Remote on-off
The remote on-off eliminates the need for a high current switch in the input wiring. The remote on-off
can be operated with a low power switch or by for example the engine run/stop switch (see manual).
Adjustable output voltage: can also be used as a battery charger
For example to charge a 12 Volt starter or accessory battery in an otherwise 24V system.
All models are short circuit proof and can be paralleled to increase output current
An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Input voltage range 10-17V 10-17V 20-35V 20-35V 20-35V 40-70V 40-70V 40-70V
Under voltage shut down 7V 7V 14V 14V 14V 28V 28V 28V
Under voltage restart 7,5V 7,5V 15V 15V 15V 30V 30V 30V
Nominal output voltage 12,2V 24,2V 12,2V 24,2V 48,2V 12,2V 24,2V 48,2V
Output voltage adjust range 10-15V 20-30V 10-15V 20-30V 40-60V 10-15V 20-30V 40-60V
Output voltage tolerance +/- 0,2V
Output noise 2mV rms
Cont. output current at nominal
output voltage and 40°C 30A 15A 30A 17A 8,5A 30A 16A 8A
Maximum output current (10 s) at
nominal output voltage minus
20%
40A 25A 45A 25A 15A 40A 25A 15A
Short circuit output current 60A 40A 60A 40A 25A 60A 40A 25A
Cont. output power at 25°C 430W 430W 430W 480W 480W 430W 430W 430W
Cont. output power at 40°C 360W 360W 360W 400W 400W 360W 380W 380W
Efficiency 87% 88% 88% 89% 89% 87% 89% 89%
Off load current < 80mA < 100mA < 100mA < 80mA < 120 mA < 80mA < 80mA < 80mA
Galvanic isolation 200V dc between input, output and case
Operating temperature range -20 to +55°C (derate 3% per °C above 40°C)
Humidity Max. 95% non-condensing
DC connection Screw terminals
Maximum cable cross-section 13 mm² (AWG6)
Weight 12V input and/or 12V output models: 1,8 kg (3 lb)
Screw terminals
No special tools needed for installation.
Input fuse (not replaceable)
On 12V and 24V input models only.